531A0224H02 oil filter element replaces Frick

531A0224H02 replaces Frick oil filter element with high-strength galvanized steel inner and outer double-layer skeleton, which has high pressure resistance characteristics and can filter impurities in oil and gas with high precision. The filtration efficiency is up to 99.9%. Huayuan Environmental Protection can produce replacement 531A0224H02 oil filter element, and the product quality complies with ISO standards. And you can provide extra long warranty period.

531A0224H02 oil and gas Separation filter element is installed in the compressor oil and gas separator to remove oil mist and solid particles in the compressed air, provide clean air source for the rear system of the compressor, and the suction filter element is installed at the suction port of the compressor to filter dust and other impurities in the refrigerant, The oil filter element to protect the normal operation of the compressor is used to further remove the metal powder produced by the wear of various components in the oil and the colloidal particles produced by the chemical action of the system medium, so as to extend the service life of the compressor.

Model: York oil filter 026-32831-000.

Applicable model: screw/centrifugal unit.

Product characteristics: The end cover and framework of the filter element are made of metal. The end cover is stamped, and the framework is cut, rolled, welded, and rounded. After surface treatment and inspection, it can be used for the production of filter element. The filter layer is made of imported glass fiber material, which has good heat resistance, high temperature resistance, incombustibility, corrosion resistance, high tensile strength, good electrical insulation, low pressure, long service life, and its filtration accuracy, pressure drop, and contaminant capacity meet the requirements of the original factory. It can effectively control the cleanliness of the refrigerant oil of the compressor and make the refrigeration system operate more stably and normally for a longer time. The filter layer is folded and shaped by a corrugated machine. The filter layer is seamed with aluminum plate seaming piece, with good sealing. The wave bending process has greatly improved the contaminant absorption capacity, its compression and backwash resistance are better, and the filtering accuracy is more stable. The adhesive is a two-component high-quality epoxy resin adhesive with high and low temperature resistance, which can be used in various refrigerants and refrigerant oil at minus 40-110 ℃.